Fitting & Using The Tools On Your Multiprocessor; Stainless Steel Slicing Blades - Sunbeam MultiProcessor Compact LC5000 Instruction Booklet

Fitting & Using the tools on your
MultiProcessor
Note: All attachments must be firmly
attached to the spindle. Always adjust the
attachments until you are sure that they are
correctly fitted.
Processing blade
1.Fit the processing bowl and spindle as
detailed on page 8.
2.Remove the protective cover from the
stainless steel processing blade.
3.Fit the processing blade over the spindle
and press firmly into place.
Warning: Use extreme caution as blades are
sharp. Always handle the chopping blade by
its central plastic section.
4.Place food into processing bowl.
5.Fit the processing bowl cover to the
processing bowl. Refer to page 8 and place
the food pusher into the feed tube.
6.Process ingredients as required.
Compact
™

Stainless Steel slicing blades

1.Carefully select the desired disc to be used
(slicing or shredding).
Warning: Use extreme caution as blades are
sharp.
2.Slide the blade with sharp side facing up,
into the side grooves of the disc holder.
Continue to push the disc into place until
it covers the 2 small black tabs in the
centre of the disk holder.
3.Hold the disc by sliding your thumb and
index fingers into the holes of the disc
holder. Place the assembled discholder
onto the spindle.
4.Place food into processing bowl.
5.Fit the processing bowl cover to the
processing bowl. Refer to page 8 and
place the food pusher into the feed tube
6.Process ingredients as required.
9