Table of Contents
Advertisement
Minimum distances
Dimension
A
B
Levelling
Use small feet on the bottom of appliance to
set same level of cooker top surface with other
surfaces
Electrical installation
Warning! Only a qualified and competent
person must do the electrical installation.
Environment concerns
The symbol
on the product or on its
packaging indicates that this product may not
be treated as household waste. Instead it
should be taken to the appropriate collection
18
B
A
A
mm
2
685
The manufacturer is not responsible if you
do not follow safety precautions from the
chapter "Safety information".
This appliance is supplied without a main plug
or a main cable.
Covering terminal board
The recommended cross-section area is six
square millimetres (6 mm²).
When you refit the mains terminal cover, make
sure that the lower tabs are located inside the
bottom edge of the aperture, before you fix the
two screws into the top edge of the mains ter-
minal cover.
Make sure that the cover is securely fastened.
To open the cover of terminal board obey
the procedure in opposite sequence.
Terminal board
Make sure that the links are fitted as shown.
L
L
Do not remove blanking plates.
point for the recycling of electrical and
electronic equipment. By ensuring this product
is disposed of correctly, you will help prevent
potential negative consequences for the
environment and human health, which could
N
N
N
www.zanussi.com
Advertisement
Table of Contents
