Environment Concerns - Zanussi ZCG551GNC User Manual

2. Examine the supply pressure by turning the
Rapid burner and one other burner fully on,
and lighting them. The pressure must be:
a) 20 mbar for Natural Gas
b) 29 mbar for LPG, butane only
c) 37 mbar for LPG, propane only.
3. Turn the taps off and disconnect the pres-
sure gauge.
4. Make sure that all burners work correctly.
Checking the grill
1. Put in the grill pan containing the grid.
2. Light the grill burner by turning the grill con-
trol knob to the symbol
3. Release the knob when the burner comes
on.
Checking the hob burners
1. Lift the lid.
2. Put in the burner crowns and caps. Make
sure that they are correctly seated.
3. Put in the pan supports.
4. Check each of the burners in turn by turning
the burner control knob to the symbol
5. Release the knob when the burners come
on.
Checking the lid shut-off device
1. Lift the lid.
2. Light one of the hob burners.
3. Close the lid. There should be no gas sup-
ply to the hob burners. The burner goes out.
4. Turn the burner off and lift the lid. The gas
supply should be restored to the hob burn-
ers, when you turn the knob on.

Environment concerns

The symbol on the product or on its
packaging indicates that this product may not
be treated as household waste. Instead it
should be taken to the appropriate collection
point for the recycling of electrical and
electronic equipment. By ensuring this product
is disposed of correctly, you will help prevent
potential negative consequences for the
www.zanussi.com
Checking the main oven
1. Turn the gas oven control knob to the sym-
2. When the oven burner comes on, the gas at
3. When the FSD heat sensor is heated suffi-
4. After 1 minute make sure that the flame
5. Set the oven control knob to the maximum
.
6. Turn the control knob off and check that the
Electrical installation
the chapter "Safety information".
.
This appliance is supplied with a main plug and
a main cable.
the time.
MANUFACTURER:
ELECTROLUX POLAND Sp.z o.o..
ul.Kazimierza Odnowiciela 28
58-100 Świdnica - POLAND
environment and human health, which could
otherwise be caused by inappropriate waste
handling of this product. For more detailed
information about recycling of this product,
please contact your local council, your
household waste disposal service or the shop
where you purchased the product.
bol .
first flows to the oven burner slowly, at the
FSD by-pass rate.
ciently, it opens the FSD valve. The main
gas stream flows to the burner.
covers the full width of the burner and is
stable.
position and close the oven door. After
about 10 minutes the flame size should de-
crease.
oven flames go out.
The manufacturer is not responsible if you
do not follow the safety precautions from
Connect the phases correctly, if you do
not connect, spark generator will work all
23