Speaker Assembly - HP COMPAQ 6510B Maintenance And Service Manual

14. If it is necessary to replace the modem module cable, disconnect the cable (1) from the modem
module and the system board (2), and remove the modem connector (3) from the clip built into the
base enclosure.
NOTE:
Reverse this procedure to install the top cover, microphone, Bluetooth module cable, and modem
module cable.

Speaker assembly

Description
Speaker assembly
Before removing the speaker assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Memory/WLAN module compartment cover (see
c. Optical drive (see
d. Keyboard (see
e. Switch cover (see
The modem module cable is available in the Cable Kit, spare part number 443887-001.
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Switch cover on page
46).
50)
Expansion memory module on page
60)
62)
68)
Component replacement procedures
Spare part number
443909-001
54)
83