Pc Card/Audio Board Assembly - HP COMPAQ 6510B Maintenance And Service Manual

PC Card/audio board assembly

Description
PC Card/audio board assembly
Before removing the PC Card/audio board assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Memory/WLAN module compartment cover (see
c. Optical drive (see
d. Keyboard (see
e. Switch cover (see
f. Fan (see
g. Heat sink (see
h. Display assembly (see
i. Top cover (see
j. System board (see
Remove the PC Card/audio board assembly:
1. Remove the Phillips PM2.5×5.0 screw (1) that secures the PC Card/audio board assembly to the
system board.
2. Lift the left side of the PC Card/audio board assembly (2) until it disengages from the system board.
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Switch cover on page
Fan on page 69)
Heat sink on page
Display assembly on page
Top cover on page
System board on page
46).
50)
Expansion memory module on page
60)
62)
68)
71)
75)
79)
86)
Component replacement procedures
Spare part number
443889-001
54)
89