Table of Contents
Advertisement
THREAD CHAINSTITCH/
COVERSTITCH LOOPER (NAVY BLUE)
•
Raise the presser foot to release tension discs.
•
Pass the thread from back to front through the thread
guide on the thread stand (1).
•
Thread the top cover thread guide by pulling the thread
towards the left until it slips under the guide. Then pull
the thread along the right side of the button as illustrated
(2).
•
While holding the thread with both hands, pass it
between the tension discs and pull it down to make
certain it is properly placed between the tension discs (3).
•
Turn the hand wheel toward you until the Chainstitch
looper is at the far right.
•
Thread the looper area of the machine following the blue
color coded thread guides (4-11).
•
Place the thread through threading guide (4).
•
Place the thread through the front slot of threading guide
(5).
•
Continue threading through guides 6-7.
•
Thread the Chainstitch thread guide (8) by holding the
thread in front of the thread guide pin and pulling the
thread backward and up, until the thread rests inside the
thread guide loop and under the spring.
•
To thread the last thread guide (10), pull about 10 cm (4")
of thread through guide 9.
Option 1
Place the thread into the "V" cutouts (A) on threader
lever. Pull the threader lever (B) up into place and back to
snap the thread into thread guide 10. Thread the looper
eye (11) from front to back using the tweezers.
Option 2
Thread the looper eye (11) from front to back using the
tweezers. Make sure the thread runs into the left "V"
cutout (A) on threader lever. Firmly hold the thread tail
with your left hand and pull the threader lever (B) up into
place and back to snap the thread into thread guide 10.
16
2
11
10
9
8
10
A
Option 1
2
3
4
5
7
A
B
Option 2
1
6
B
Hide quick links:
Advertisement
Table of Contents
