Electrolux Iron AidTM EDI97170W User Manual page 21

After a IronAid pro-
gramme, garments are
not sufficiently smooth.
After a IronAid pro-
gramme, there are no
creases left in the gar-
ments.
Drying results unsatisfac-
tory.
When a button is pressed
- no reaction of the ma-
chine.
Drum light does not work.
Displayed programme
time changes erratically or
stays unchanged for a
long time.
Wrong programme selected (e.g.
SYNTHETICS instead of
COTTON).
Too low a LOAD level set.
Too many garments in machine, or
garments that are too different.
Clothes are not removed until the
anti-crease phase is finished.
Garments not hung on clothes
hangers and/or not tugged into
shape.
Multi-layered garments tend to lose
their shape.
The IronAid programme has the ef-
fect of smoothing garments.
Wrong programme selected.
Lint filters clogged.
Fluff filter clogged.
Heat exchanger clogged with lint.
Overloading of laundry.
Ventilation slots in base area cov-
ered up.
Residue on inside surface of drum
or drum ribs.
Conductance of water at installa-
tion site differs from standard set-
ting of machine.
Drying protection. After the start of
the programme, the option can no
longer be set.
Programme selector in OFF posi-
tion.
Defective light bulb.
Programme time is corrected auto-
matically depending on type and
volume of laundry and level of
dampness.
Note the composition of the fabric.
Set a higher LOAD level.
Load the machine with fewer gar-
ments, or only similar ones.
Remove clothes quickly one at a
time from the machine as soon as
possible after the start of the anti-
crease phase.
Hang garments on clothes hang-
ers, do up buttons and tug gar-
ments into shape.
Reshape multi-layered garments by
ironing after they come out of the
machine.
Iron creases in again after the Iron-
Aidprogramme.
Select a different programme the
next time you dry (see "Programme
overview" chapter).
Clean lint filters.
Clean fluff filter.
Clean heat exchanger.
Observe recommended loading
volumes.
Uncover ventilation slots in base
area.
Clean inside surface of drum and
drum ribs.
Make an adjustment using the
DRYNESS function (see chap-
ter "Drying")
Re-programme standard setting for
degree of drying (see 'Program-
ming options' chapter).
Turn the programme knob to OFF.
Set the programme again.
Turn programme selector to any
programme.
Replace light bulb (see next sec-
tion).
Automatic process; this is not a
machine fault.
electrolux 21