Electrolux ESF 65060 User Manual page 20

20 electrolux
Make sure that there are no kinks in the water
inlet hose and that the water inlet hose is not
squashed or entangled.
Fit the hose nut correctly to prevent water
leaks.
Caution! Do not connect the appliance
to new pipes or pipes that have been not
used for a long time. Let the water run
for some minutes, then connect the inlet
hose.
The water inlet hose is double-walled and
has an inner mains cable and a safety valve.
The water inlet hose is under pressure only
while the water is running. If there is a leak in
the water inlet hose, , the safety valve inter-
rupts the running water.
Be careful when you install the water inlet
hose.
Warning!
• The mains cable is in the double-wal-
led inlet hose. Do not immerse the wa-
ter inlet hose or the safety valve in wa-
ter.
• Do not attempt to shorten the inlet
hose.
• If the water inlet hose or the safety
valve is damaged, immediately turn off
the power and remove the mains plug
from the mains socket.
• Only a qualified Service Engineer can
replace the water inlet hose with safe-
ty valve.
Warning!
Dangerous voltage
In order to pass the safety valve through
the kitchen cabinets, an opening of at
least 45mm x 90mm is needed.
Water drain hose
The highest point of the drain hose must be
no more than 60 cm from the floor and must
have a continuous fall to the plumbing con-
nection.
The drain hose can be lengthened using ad-
ditional lengths and connectors. These must
be purchased from Electrolux Spare Parts.
The extension length must not exceed 2 me-
tres.
The drain hose must be free of kinks and ob-
structions.
Remove the sink plug when the appliance
drains the water to prevent that the water
goes back into the appliance.
If you connect the water drain hose to a trap
spigot under the sink, remove the plastic
membrane. If you do not remove the mem-
brane, remaining food can cause a blockage
in the drain hose spigot.
The appliance has a security feature to
prevent dirty water going back into the
appliance. If, the spigot of the sink has a
'non-return valve', this valve can cause
the appliance to drain incorrectly. Re-
move the non-return valve.
Caution! Make sure that the water
couplings are tight to prevent water
leakage.
Ensure that hoses are not crushed or
kinked under or behind the appliance.
Once connected the inlet hose to the
water tap, turn the tap on and check that
there are no leaks.