Table of Contents
Advertisement
Available languages
Available languages
Troubleshooting
There is detergent left on the laundry. (**)
• Excessive laundry was loaded in. >>> Do not load the machine in excess.
• Wrong programme and temperature were selected. >>> Select the proper programme and temperature for the
laundry to be washed.
• Wrong detergent was used. >>> Select the proper detergent for the laundry to be washed.
Too much foam forms in the machine.(**)
• Improper detergents for the washing machine are being used. >>> Use detergents appropriate for the washing
machine.
• Excessive amount of detergent is used. >>> Use only sufficient amount of detergent.
• Detergent was stored under improper conditions. >>> Store detergent in a closed and dry location. Do not store
in excessively hot places.
• Some meshed laundry such as tulle may foam too much because of their texture. >>> Use smaller amounts of
detergent for this type of item.
• Detergent is put in the wrong compartment. >>> Put the detergent in the correct compartment.
• Softener is being taken early. >>> There may be problem in the valves or in the detergent dispenser. Call the
Authorized Service Agent.
Foam is overflowing from the detergent drawer.
• Too much detergent is used. >>> Mix 1 tablespoonful softener and ½ l water and pour into the main wash
compartment of the detergent drawer.
• Put detergent into the machine suitable for the programmes and maximum loads indicated in the "Programme
and consumption table". When you use additional chemicals (stain removers, bleachs and etc), reduce the
amount of detergent.
Laundry remains wet at the end of the programme (*)
• Excessive foam might have occurred and automatic foam absorption system might have been activated due to
Machine does not start. Nothing appears on the display.
too much detergent usage. >>> Use recommended amount of detergent.
Machine may be unplugged. >>>
Fuse may be defective. >>>
Power may be out. >>>
On / Off button might not be pressed. >>>
Machine does not start when Start / Pause / Cancel button is pressed after selecting the programme.
Loading door may be open. >>>
Rinse symbol flashes in the display. (No Water symbol may also be lit depending on the model of your
machine).
Water may be cut off. >>>
again to start your machine.
*
Machine does not switch to spinning step when the laundry is not evenly distributed in the drum
to prevent any damage to the machine and to its surrounding environment. Laundry should be
rearranged and re-spun.
** Regular drum cleaning is not applied. >>> Clean the drum regularly. For this, please see 7.2.
WARNING:
A
consult your dealer or the Authorized Service Agent. Never try to repair a nonfunctional product
yourself.
Washing Machine / User's Manual
Check the plug and attach it to the socket.
Check the fuse and have it replaced by a qualified electrician if necessary.
Check if there is any power outage.
Press On / Off button.
Close the loading door.
Make sure that the water is not cut off and press Start / Pause / Cancel button
If you cannot eliminate the problem although you follow the instructions in this section,
35 / 36 EN
Advertisement
Table of Contents
