If the unit is not working properly, this may be due to small problems that you can easily resolve yourself.
Follow these instructions carefully before contacting your local Authorised Technical Service Centre.
PROBLEM
The air conditioner is
•
it is not plugged in
there is no electricity
completely turned
•
off
the air conditioner is
9
on (signal light
)
•
The notches of the timer are in the rest mode
but the appliance
doesn't start
The unit works but
•
three minutes have not passed since it was
does not cool the
turned on
room
•
windows open
•
a heat source is operating in the room (burner,
light, etc.) or there are a lot of people
•
the air outlet hose has come detached from
the coupling
•
thermostat adjusted too high
•
air filters clogged
•
the output of the unit is insufficient for the con-
ditions or size of the room
•
there is a kink in the exhaust hose
The unit works for
•
the exsaust hose is blocked
only a short time
•
there are too many curves in the outlet tube
•
the fan is blocked
14
Troubleshooting
CAUSE
REMEDY
•
plug in
•
wait
•
proceed with a new setting of
the timer
•
wait three minutes (safety devi-
ce) before the appliance start
cooling.
•
close the windows
•
eliminate heat sources
•
fit the hose in the coupling
•
lower the thermostat
•
clean/replace filters
•
position the exhaust hose correctly
•
check there are no blockages
preventing the discharge of air
to the outside
•
rearrange the hose correctly
•
contact the Service Centre