Table of Contents
Advertisement
S e l e c t i n g f u n c t i o n s
AIR CONDITIONING FUNCTIONS
To turn the unit on in air conditioning mode,
proceed as follows:
1. Press the
button
10
9
will come on).
2. Rotate the function selector
clockwise:
• Place the large star symbol
the reference mark to operate the unit in
air conditioning mode at maximum fan
speed (the signal light
and then, after 3 minutes the signal light
will come on ).
14
• Place the small star symbol
the reference mark to operate the unit in
air conditioning mode at minimum fan
speed (the signal light
and then, after 3 minutes the signal light
15
will come on ).
3. Now set the required temperature by rota-
ting the room thermostat dial
Note
The temperature is not expressed in degrees.
We recommend that you turn the thermostat
dial to the maximum position. When the desi-
red room temperature has been reached,
slowly turn the thermostat in a clockwise
direction until it arrives at the position where a
click can be heard. The signal lights
(or
) will turn off.
14
15
The temperature selected in this way will
automatically be regulated and maintained,
and save energy. When regulating the ther-
mostat, the air conditioning function is tem-
porarily interrupted and the unit continues to
operate in fan only mode. In this way, the
appliance keeps the air temperature within
the room even.
Delay on Start Up
1. A special safety device will delay the start
of air conditionig by approximately 3 to 5
minutes when switching between func-
tions or on initial start up.
2. You may also experience a slight delay
between changing from one function to
another.
10
TURBO POWER
The Turbo Power mode was designed to pro-
vide the appliance with a greater cooling
potential. This is particularly useful when you
(the signal light "I"
want to bring the temperature of a very
warm room quickly down to a more comfor-
table level. In this case:
18
dial anti-
Make sure that the tank is full of water (see
page 22);
in line with
Make sure that the function selector switch
18
will come on,
21
Press the Turbo Power button
After reaching the desired temperature, you
can release the Turbo Power button and
in line with
reposition the selector switch to the small cry-
stal. Doing so will make the operation quiter.
21
will come on,
VENTILATION/FILTRATION
Rotate the function selector
• Press the
.
19
• Place the large symbol
• Place the small symbol
and
21
PURIFICATION FILTER (Only for some
models)
In addition to dust, this purification filter is able
to capture even the smallest sized particles
and impurities (up to 0.003 millimetres), such
as cigarette smoke.
The purification filter should never be used
with the dust filter, which is also included with
the appliance. Therefore:
A. If you wish to use the purification filter:
Remove the purification filter from the filter
housing;
Remove the aspiration grill
page 24) and the dust filter which is attached
to this.
Remove the purification filter from its packa-
ging.
is in the large crystal position.
18
button
10
(the signal light "I"
9
will come on).
) in line with the reference mark to ope-
rate the unit at maximum fan speed. (the
signal light
17
will come on).
(or the symbol
in line with the reference mark to operate
the unit at minimum fan speed. (the signal
light
16
will come on).
20
.
clockwise.
(or the symbol
)
6
(fig. G on
Hide quick links:
Advertisement
Table of Contents
