Code Hopping; Owner Recognition - Directed Electronics 435 Owner's Manual

Hide thumbs Also See for 435:

Table of Contents

Code Hopping

The receiver and transmitter use mathematical formulas called algo-

rithms to change their codes each time the transmitter is used. This

Code Hopping technology has been developed to increase the secu-

rity of the unit. By following this set code sequence, the receiver and

transmitter stay synchronized, even if the remote transmitter is used

out of range of the vehicle. If, however, the transmitter is pressed many

times out of range of the vehicle, or the battery is removed, the trans-

mitter may get temporarily out of sync and fail to operate the system.

To resynchronize the remote transmitter, simply press

times within range of the vehicle. The system will automatically re-

synchronize and the transmitter will respond normally.

Using a system programming device, your dealer can program specific

settings for each transmitter that is used with your system. The sys-

tem is then capable of recalling the individual settings assigned to

each transmitter. This Owner Recognition feature allows up to four

users of the same system to have four different settings that meet

their individual needs.

NOTE: Owner Recognition cannot be programmed without a system pro-

gramming device and the necessary software. Check with your dealer for

more information.

several

1999 Directed Electronics, Inc.

Table of Contents