Fireplace Installation; Operation - Dimplex BF362SD Owner's Manual

Fireplace Installation

Bathroom Installation
This firebox must be protected
by a GFI circuit. If a receptacle
is used it must be readily
accessible.
To prevent electrical shock this
unit is an electrical appliance
that is not watertight and must be

Operation

WARNING: This electric
firebox must be properly installed
before it is used.
Manual Controls
(Figure 1)
The controls for the Electric Fire-
place are located at the bottom
right hand corner of the unit.
A. On/Off Switch
The on/off switch energizes the
firebox and flame.
B. Mode Selector Switch
Select preferred feature:
• "o" for flame only
• "-" for Purifire
• "=" for heat/Purifire
!
NOTE: Hot air will blow from
both sides of the fireplace when
6
only/flame.
TM
/flame
TM
installed as to prevent water from
entering the unit. This unit must
be installed away from showers,
tubs, etc. Never locate fireplace
where it may fall into a bathtub or
other water containers. Keep tow-
els and other combustible materi-
als 3 feet (0.9 m) away from the
front of the unit.
the heater is activated. The heater
may emit a slight, harmless odor
when first used. This odor is a
normal condition caused by initial
heating of internal heater parts
and will not occur again.
Resetting The Temperature
Cutoff Switch
The heater on this fireplace is
protected with a safety device to
prevent overheating. Should the
heater overheat, the Overheat
indicator will be activated (Fig. 1),
and an automatic cutout will turn
the heater off and it will not come
back on without being reset. It
can be reset by switching the On/
Off switch to OFF and waiting 5
minutes before switching it to ON.
www.dimplex.com