Table of Contents
Advertisement
Engine Oil
Mini bike may have oil in it when
shipped from the factory.
However, it is a good idea to
drain this oil and replace with
new SAE 10W-30 Motor Oil.
Changing the engine oil
1. Remove the oil fill plug (1)
2. Remove the drain bolt (2) located on
the bottom of the engine.
3. Allow the oil to drain in an appropriate
container. Note: Dispose of oil at an oil
recycle center.
4. Install the drain plug and fill with SAE
10W-30 motor oil. This mini bike takes
.63qt. (.6L) of engine oil. Oil should be up
to the brim of the fill hole.
5. Re- install fill cap, Start engine and
allow to run for a few minutes, Re-check
oil level and fill accordingly.
Caution: Do not over or under fill
with Motor Oil
FUEL
Never use leaded gasoline in this product.
It could affect the engine's emissions and
damage the engine.
Mini Bike requires clean unleaded regular
gasoline with a minimum octane rating of
86 or higher.
Fill with gasoline up to the bottom of the
filler neck.
OIL AND FUEL
6
1
1
2
Filler neck
Fill level
Fuel level
Advertisement
Table of Contents
