Mounting The Monitor To A Desktop - HP L5006tm User Manual

Ä
CAUTION: This monitor supports the VESA industry standard 75mm
mounting holes. To attach a third party mounting solution to the
monitor, four 4mm, 0.7 pitch, and 10mm long screws are required
(not provided with the monitor). Longer screws should not be used
because they may damage the monitor. It is important to verify that
the manufacturer's mounting solution is compliant with the VESA
standard and is rated to support the weight of the monitor display
panel. For best performance, it is important to use the power and
video cable provided with the monitor.
To remove the stand and mount the panel:
1. Turn off the monitor and computer.
2. Disconnect the power, USB or serial and video cables from
the monitor and the computer.
3. Lay the monitor face down on a flat surface covered with soft
protective cloth.
4. Remove the four screws that secure the stand to the back of
the monitor.
5. Follow the instructions from the manufacturer to install the
panel to the manufacturer's mounting fixture.
6. Reconnect the power, USB or serial and video cables to the
monitor and the computer.
7. Turn on the computer, then turn on the monitor.

Mounting the Monitor to a Desktop

The monitor can be screwed down on a desktop or a tabletop to
provide security. Four mounting holes are available on the base of
the stand for mounting the monitor.
1. Turn off the monitor and computer.
2. If necessary, disconnect the power, USB or serial and video
cables from the monitor and the computer.
User Guide
Setting Up the Monitor
3–5