HP L5006tm User Manual page 28

■
Be sure to calibrate the touchscreen monitor. Touch response
must be aligned to the video image (this is sometimes called
calibration). Normally this need only be done when the touch
drivers are initially installed.
To calibrate the touchscreen:
1. Click the Windows Start button.
2. Select Settings > Control Panel (on later operating systems
the Settings step is omitted).
3. Open the Elo application by double-clicking the Elo icon.
On Windows XP it may be necessary to click the Show
Classic View button on the left side of the screen to see the
Elo icon.
4. Click the Alignment/Calibration button.
The Alignment/Calibration button is always on the General
tab of the Elo Control Panel tab set. It may be titled Calibrate,
Align or it may just be an icon (fingers and cross marks on a
display).
5. Touch the target that is displayed in the upper left corner. The
target will reappear in the lower right corner.
6. Touch the lower right target. The target will reappear in the
upper right corner.
7. Touch the upper right target. The next screen is an alignment
check.
8. On the alignment check screen, touch various places on the
screen and see that the cursor jumps to the point of touch.
A progress bar displays the relative time remaining before the
routine will time out; if time-out is reached, the routine is
aborted and the new alignment points are not retained.
If response is correct, touch the Accept button - it may be a
Yes button or a green check.
User Guide
Troubleshooting
A–3