Honda P/N 08E51-S01-101F Installation Instructions Manual page 6

Installing the Control Unit
16. Loosen the bolt on the right of the steering shaft,
then slide the slot of the control bracket under the
head of the bolt you just loosened.
CONTROL BRACKET
EXISTING BOLT
(Reuse on A/T
model vehicle.)
VEHICLE
BOLT
(Reuse on A/T
model vehicle.)
CONTROL BRACKET
17. Align the upper hole in the control unit bracket with
the hole in the dash, and install the 6 x 12 mm
flange bolt supplied. Tighten the 6 x 12 mm bolt, and
the bolt you loosened in step 16 securely.
On A/T model vehicles, attach the control unit
bracket under the interlock control unit, and reuse
the existing bolt.
6 of 10
INTERLOCK
CONTROL UNIT
(A/T only)
6 x 12 mm
FLANGE BOLT
(supplied)
HOLE
SLOT
AII 20447 (9908)
18. Position the control unit on the control bracket and
install the two collars and two 4 x 30 mm bolts.
19. Cut the cushion tape in two, and attach the pieces to
the bracket of the steering shaft.
CUSHION TAPE
© 1999 American Honda Motor Co., Inc - All Rights Reserved.
CONTROL UNIT
4 x 30 mm
BOLTS
COLLARS
BRACKET