Honda P/N 08E51-S01-101F Installation Instructions Manual page 10

34. Plug the 3-pin connector marked C of the security
harness into the 3-pin connector from the disarm
switch.
SECURITY HARNESS
3-PIN CONNECTOR
VEHICLE
HARNESS
FUSE
BOX
CUSHION
TAPE
VEHICLE
(half)
HARNESS
35. Wrap half of a cushion tape around the 3-pin
connectors, then secure them to the vehicle harness
with one wire tie as shown.
10 of 10
INSPECTION
36. Check that all wire harnesses are routed properly
37. Reinstall all removed parts.
38. Connect the negative cable to the battery.
DISARM SWITCH
3-PIN
CONNECTOR
39. Check operation of the Security System according
40. For Continuously Variable Transmission (CVT) only:
41. Put the Security System Attachment Owner's
WIRE TIE
DISARM
SWITCH
HARNESS
AII 20447 (9908)
and all connectors are plugged in.
to its Owner's Manual supplied with the Security
Attachment.
perform the start clutch calibration procedure
according to the Service Manual whenever the
battery is disconnected of the battery backup fuse is
removed.
Manual in the glove box for your customer.
© 1999 American Honda Motor Co., Inc - All Rights Reserved.