Honda P/N 08E51-S01-101F Installation Instructions Manual page 5

11. Carefully push the LED terminals into the 2-pin
connector from the kit.
Insert.
2-PIN
CONNECTOR
Firmly push the terminal into
the connector until they click
into position.
Installing the Disarm Switch
12. Mark the dashboard lower cover in the area shown.
While wearing eye protection, lightly center-punch
the mark, and drill a 12 mm hole through the center-
punched mark.
12 mm
DRILL BIT
DASHBOARD
LOWER COVER
© 1999 American Honda Motor Co., Inc - All Rights Reserved.
LOCK
Insert the tabs into the
grooves, slide the lock
toward the front, and
press down on the end.
WHITE WIRE
RED WIRE
14 mm
20 mm
13. Route the terminal ends of the disarm switch
harness through the 12 mm hole you just drilled in
the dashboard lower cover. Secure the disarm switch
on the dashboard lower cover using the 12 mm nut
and washer provided. Tighten the nut securely.
DISARM SWITCH
14. Firmly push the terminals of the disarm switch into
the 3-pin connector provided until they click into
position.
15. Pull gently on the wires to verify that they are locked
in the connector. Make sure that the terminals are
positioned properly, then lock the connector.
Firmly push the terminal
into the connector until
they click into position.
Insert the tabs into the grooves, slide
the lock toward the front, and press
down on the end.
AII 20447 (9908)
12 mm NUT
WASHER
PREDRILLED
HOLE
DASHBOARD
LOWER COVER
BLUE WIRE
BLACK
WIRE
DISARM
SWITCH
3-PIN
CONNECTOR
5 of 10