Tzora EasyTravel Elite ET1E User Manual page 13

5.7. Batteries
Battery information
The EasyTravel Elite is designed to use sealed lead acid, maintenance-
free, 12V batteries.
Always turn your EasyTravel Elite OFF before removing and installing
batteries. To get the maximum out of your batteries, it is recommended to
fully charge the batteries overnight after every day of use. Reconnecting
the charger when the batteries are partially discharged or fully
charged will not harm them. Extended charging is good for the batteries
and you cannot overcharge them.
Battery range depends on operator weight, terrain and the condition of
batteries used. Charge your batteries daily and/or overnight when the
EasyTravel Elite is not in use.
Battery Recharging Instructions
To recharge, turn off EasyTravel Elite It is possible to either charge the
battery while connected on the EasyTravel Elite (see instruction 1 below)
or directly (instruction 2).
1. Plug the charging connector into the EasyTravel Elite charging
socket and then connect the charger to an electrical outlet socket.
2. Plug the charging connector in the back of the battery pack and then
connect the charger to an electrical outlet socket.
During charging, the indicator light on the charger will be orange. When
the battery is approaching full charge the indicator light will turn green. In
order to achieve the maximum battery capacity and efficiency, it is ad-
vised to charge them overnight, and at least four hours after the indicator
light has turned to green.
Safety Instructions
CAUTION: Failure to follow these instructions may result in personal in-
jury or property damage.
1. Never smoke or allow an open flame in the vicinity of the batteries.
2. Use the charger for charging lead acid batteries only. It is not in-
tended to supply power to an extra-low-voltage electrical system or to
charge dry cell batteries.
3. Never charge a frozen battery.
EasyTravel Elite – ET1E User's Manual Rev. 0708 13