Operating Your Easytravel Elite - Tzora EasyTravel Elite ET1E User Manual

5. OPERATING YOUR EasyTravel Elite

5.1. Control Panel operation features
The switch located on the right side of the control panel (Fig. 9/1), will turn
the power of the EasyTravel Elite ON or OFF.
NOTE: Turn your EasyTravel Elite switch to the OFF position when not in
use in order to conserve battery power, and prevent unintentional operation.
The top speed may be adjusted by turning the Speed-adjusting knob (fig
9/3). By turning the knob to the HI position, your EasyTravel Elite's top
speed will be up to 3.7mph/6kph. When the knob is set to the Lo position,
the speed will be reduced to a slow crawl, ideal for less experienced driv-
ers and for operating indoors.
5.2. Indicator light (Fig. 9/4)
The light, located at the bottom of the handle control cover, displays bat-
tery status and fault indications as follows:
Indicator light steady - This indicates that all is well.
Indicator light flashes slowly - The controller is functioning cor-
rectly but batteries should be charged as soon as possible. The Bat-
tery Gauge (Fig. 9/5) shows the charge that is left.
Indicator light flashes rapidly - This indicates that there is a fault.
Please follow the following procedure:
1. Switch off the EasyTravel Elite
2. Make sure that the EasyTravel Elite is not in the FREEWHEEL
position.
3. Make sure that the charger is not connected to the EasyTravel Elite.
4. Make sure that the control lever is in the middle position.
CAUTION: If control lever does not return by itself to the middle po-
sition – do not operate. Contact your service agent.
5. Switch the EasyTravel Elite on again and try to drive. If the indi-
cator light flashes rapidly again, switch off and do not operate.
Contact your service agent!
EasyTravel Elite – ET1E User's Manual Rev. 0708 11