Installation And Adjustment Of Work Stop; Starting The Saw - Jet J-7040 Operating Instructions And Parts Manual

Angle
Setting
Block
Left
Vise
Jaw
Angle
Locking
Screw
Figure 6: Adjusting vise
Angle Block
Locking Handle
Angle
Pointer
Figure 7: Angle setting block
Installation and Adjustment of
Work Stop
Figure 5: Securing workpiecThe work stop is used
to set up the saw for making multiple cuts of the same
length (see figure 8). Install and adjust the work stop
as follows:
10
Figure 8: Work stop
1. Insert the end of the stop rod in the hole in the front
right side of the work table.
2. Tighten the "wing" screw to secure the rod in place.
3. Install the stop post in the channel on the back of
the stop L-bracket. Install the locking lever in the
threaded hole in the stop post. Snug-up the lock-
ing lever.
4. Install the locking knob in the hole in the side of the
stop L-bracket.
5. Slide the assembled stop L-bracket onto the stop
rod. Position the stop post against the work piece
and tighten the knob in the stop L-bracket. The
stop post can be moved left or right as required to
Set Workpiece
Against Corner
of Right
Vise Jaw
Pivot
Screw
Stop Post
Locking Lever
"Wing" Screw
Stop L-Bracket
Knob
Stop Rod
place it against the work piece.

Starting the Saw

WARNING: NEVER OPERATE THE SAW WITHOUT
BLADE COVERS IN PLACE AND SECURED.
CAUTION: MAKE SURE THE BLADE IS NOT IN CON-
TACT WITH THE WORKPIECE WHEN THE MOTOR
IS STARTED. DO NOT DROP THE SAW HEAD ON
THE WORKPIECE OR FORCE THE SAW BLADE
THROUGH THE WORKPIECE.
1. Raise the saw head. With the saw motor off, pull
the red release button on the electro-magnetic valve
and check the rate at which the saw head lowers.
2. Raise the saw head. Push in red release button.
3. Clamp the workpiece in the vise. (See figure 9 for
examples of workpieces in the vise.)
4. Be sure the blade is not in contact with the workpiece
when the motor is started.
5. Start the motor and allow the saw to come up to
speed.
6. Slowly set the saw down onto the workpiece. Adjust
cutting speed with feed rate control valve.
7. DO NOT DROP THE SAW HEAD OR FORCE THE
CUT. Let the weight of the saw head provide the
cutting force.
8. The saw will automatically shut off at the end of the
cut.
Flats/strips
Channels
Squares/rectangles
Hexagonals
Figure 9: Placing workpieces in the vise
Rounds
Knock off
sharp edge
f f
here with
file
f
I-Beams
Angles
Knock off
sharp edge
f
here with
file
f
Tees