Weider WESY87100 User Manual page 10

15. Route the Long Cable (23) around the "V"-
Pulley (6) on the Right Arm (48). Be sure
that the Cable is in the groove of the "V"-
Pulley and that the Long Cable Trap (50) is
turned to hold the Cable in place. Tighten
the 3/8" x 2 1/2" Bolt (7) and the 3/8" Nylon
Locknut (not shown).
16. Route the Long Cable (23) around the 3 1/2"
Pulley (15) attached to the Pulley Bracket
(20). Be sure that the Cable is in the
groove of the Pulley and that the Cable
Trap (66) is turned to hold the Cable in
place. Tighten the 3/8" x 2" Bolt (12) and the
3/8" Nylon Locknut (not shown).
Be sure that the 5/16" x 5" Bolt (68) is proper-
ly tightened and that the Pulley Bracket (20)
can move freely.
17. Refer to the inset drawing. If the 3 1/2" Pulley
(15) is pre-attached to the Long "U" Bracket
(57), remove it. Wrap the Long Cable (23)
around the 3 1/2" Pulley. Attach the Pulley
and two Pulley Covers (78) to the indicated
hole in the Long "U"-Bracket with a 3/8" x 2"
Bolt (12) and a 3/8" Nylon Locknut (21). Make
sure that the Pulley Covers are turned so
the wide tabs are on the indicated side.
Be sure that the Cable is in the groove of
the Pulley and that the Cable and Pulley
move smoothly.
18. Note: The Pulley (15) in this drawing is
pre-assembled. It is shown disassembled
for easy part identification.
Route the Long Cable (23) around the 3 1/2"
Pulley (15) attached to the bracket on the Top
Frame (55). Tighten the 3/8" x 2" Bolt (12)
and the 3/8" Nylon Locknut (21). Be sure that
the Cable is in the groove of the Pulley
and that the Cable and Pulley move
smoothly.
15
23
16
68
20
12
23
17
78
Wide
Tabs
21
57
18
55
21
10
7
50
6
48
66
15
23
23
15
12
15
23
Bracket
12