Care | Descaling
Descaling
Replace the water tank filled with descaling
solution, and confirm on the display
Descaling starts. This part of the routine takes
approx. 40 minutes.
Remove water tank and empty out remaining
descaling solution
Rinse the water tank and fill to the maximum level
with cold water
Insert the water tank
rinsing
Rinsing starts. After the initial rinsing from the water
tank, the display requests that the water supply
be turned on again. This part of the routine takes
approx. 40 minutes.
Turn on main water supply tap
Leave the water tank in place.
The water tank coupling is rinsed for
approx. 10 seconds from the mains supply
Remove water tank and dry
Turn and remove seal plug on water tank coupling
in a clockwise direction (flat screwdriver, see
illustration 1 and 2)
Dry the water tank and replace it
Turn on main water supply tap
Subsequent rinses are from the mains supply.
Burn hazard
• After the final rinsing the steam boiler
is heated up. The hot water expands and
finally exits briefly as steam.
> Do not reach beneath the spouts while
descaling is in progress.
> Do not touch the spouts immediately after
descaling.
The descaling is complete. Completion is indicated on
the display.
66
Illustration 1
Illustration 2
CaUtion
Observe the Safety chapter
w s tarting on page 6
User Manual WMF 1500 S