Touchpad Button Board - HP Pavilion 11 x360 PC Maintenance And Service Manual

TouchPad button board

Description
TouchPad button board (includes bracket and cable)
Before removing the TouchPad button board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the TouchPad button board:
1. Disconnect the TouchPad board cable from the system board (1).
2. Remove the two Phillips PM2.0×3.0 screws (2) that secure the bracket, and then rotate the front of the
bracket up and lift it off the computer (4).
3. Remove the three Phillips PM2.0×2.0 broadhead screws (5) that secure the TouchPad button board to
the computer.
4. Lift the foil and rubber gaskets from atop the left and right broadhead screw holes (1).
Bottom cover on page
Battery on page 49).
28).
Component replacement procedures
Spare part number
not spared
51