Final System Test & Clean-Up - Aquatic Millennium 7 Owner's Manual & Installation Manual

Millennium Owner's Manual & Installation Guide
INSTALLATION INSTRUCTIONS
FINAL SYSTEM TEST & CLEAN-UP
System Test
To test system, follow these steps in order listed:
1. Fill clean tub with water to a point no less than 2" (50) above the highest jet.
2. To test the Ground-Fault Circuit-Interrupter (GFCI), push the test button. The GFCI should interrupt power. Push the
reset button. Power should be resorted. If the GFCI fails to operate in this manner, there is a ground current flowing,
indicating the possibility of an electric shock. Do not use this unit. Disconnect the unit and have the problem corrected
by a licensed electrician before using.
3. Push on/off button on the whirlpool.
4. Allow system to run a full 10 minutes.
5. Through access door or removable skirt, check for leaks in air-whirlpool plumbing system. Make sure half-unions at
both ends of pump are hand-tight. If leakage is occurring at any other points, notify distributor.
6. If any electrical malfunctions occur, immediately unplug the unit and consult a licensed electrician. Malfunctions of the
pump/blower/motor, whirlpool controls or the circulating system should be reported to the distributor who supplied
the air-whirlpool tub.
Clean-up
1. Remove all construction residue and foreign materials. Wipe unit clean with a damp rag, otherwise staining may
occur.
2. Plaster may be removed by scraping with the edge of a piece of wood or rigid plastic. DO NOT use metal scraper.
For spots left by plaster or grout: rub lightly with a liquid detergent (Spic-N-Span® or similar) on a damp cloth or
sponge.
3. DO NOT use abrasive cleaners, scouring powders, steel wool, wire brushes or anything else that may harm or dull
the surface.
4. Paint, tar or stubborn stains may be removed with paint thinner, turpentine or rubbing alcohol. To avoid discoloration,
cleaners containing petroleum distillate must not remain on surfaces. NEVER use lacquer thinner or chlorinated
solvents.
5. Dulled areas can be restored to a high gloss with white or cream-colored automotive rubbing compound, followed by
application of carnauba wax or white or cream automotive paste wax and buffing.
6. Major gouges require professional repair. Contact Aquatic to arrange factory-authorized repair services.
Aquatic 15