Assemble 20 Amp Cutters - Century Tool 118-009 User Manual

Wheel
Wood Block
For Support
Plasma cutter
set on its side
Ground or Other
Figure 4. Install Second Wheel
9. Install the remaining washer followed by the
remaining wheel on the protruding end of the axle
as shown.
10. Using a hammer, pound the remaining plastic hub
on the end of the axle.
11. Gently tip the cutter upright onto its wheels and
support foot.
12. Position handle as shown in Figure 5 and secure it
in place with the 4 machine screws (blunt ends).
Handle
Figure 6. Install Cutter Handle, 50 Amp Cutter

ASSEMBLE 20 AMP CUTTERS

1. GENTLY, tip the cutter over onto its back on top of
the front side of the carton saved in the unpacking
section.
2. Slide the tab of the molded plastic support foot
into the slot in the bottom of the cutter, then fasten
with the two screws that have flat ends. See
Figure 7.
Hub Cap
Hard Surface
Remove Screw
(2) and Discard
Figure 7. Install Foot, 20 Amp Cutter
3. Using a hammer, pound one of the plastic hubs
onto one end of the axle (see Figure 2).
4. Slide a wheel onto the axle followed by one of the
flat washers (see Figure 3).
5. Slide axle (with wheel on it) into the hole on the
one side of the cutter, through the cutter, and out
the hole on the other side of the cutter (see
Figure 8).
Figure 8. Install Axle, 20 Amp Cutter
6. Slide remaining washer over the protruding end of
the axle followed by the remaining wheel.
7. Using a hammer, pound the remaining plastic hub
onto the axle (see Figure 4), then gently tip the
cutter upright onto its wheels and support foot.
8. Position handle as shown and attach with the 4
screws with pointed ends (see Figure 9). Tighten
securely.
E
N
G
L
I
S
H
11