Installation; Unpacking; Assembly; Assemble 50 Amp Cutters - Century Tool 118-009 User Manual

E
N

UNPACKING

G
Use the following instructions to remove your plasma
L
arc cutter from the shipping carton.
I
1. Open the shipping carton.
S 2. Remove the handle, accessory kit, and protective
top cardboard pad.
H
3. Open the accessory kit and compare the contents
to the parts and accessories list in Table 1 for a 50
amp cutter or Table 2 for a 20 amp cutter. Report
any damaged or missing items to your dealer
IMMEDIATELY.
4. With a knife, cut along the dotted line around the
bottom of the shipping carton. Be careful not to
scratch the cutter.
5. Lift off the carton and fold it down flat.
6. Place the folded carton on the floor, immediately
behind the cutter.
7. Gently tip the cutter onto its back, on top of the
folded carton

ASSEMBLY

Assemble the cutters according to the following
instructions.

ASSEMBLE 50 AMP CUTTERS

The 50 amp cutters are assembled according to the
following procedure steps and Figure 1 through
Figure 6.
1. Set the metal support foot (see Figure 1) over the
three corresponding holes on the front edge of the
bottom of the cutter.
Three Sheet
Metal Screws
Figure 1. Install Foot, 50 Amp Cutter
2. Secure the metal support foot in place with the
three sheet metal screws (pointed ends).
3. Attach the two axle brackets to the bottom of the
unit as shown in Figure 1, using two sheet metal
10

INSTALLATION

screws (pointed ends) per bracket.
4. Orient the brackets so that the downward flange of
the bracket is toward the outer edge of the cutter
as shown.
5. Using a hammer, pound one of the plastic hubs
onto one end of the axle as in Figure 2.
6. Slide a wheel onto the axle, followed by one of the
flat washers.
7. When the wheel and washer has been installed
on the axle, push axle through the hole in one of
the axle brackets, then through the cutter, and out
through the hole in the other bracket (see Figure
3).
8. Turn the cutter on the side, where the wheel has
already been installed as shown in Figure 4.
Tap Hub Cap
onto axle with
Hammer
Ground or
Hard Surface
Figure 2. Install the Hub Cap
Long Center
Hub
Axle
Washer
Figure 3. Install Wheel to Axle
Hub
Cap