Snmp Management; Configuring Snmp Settings Via Console Operation - KTI Networks KC-1300 Operation Manual

5. SNMP Management

SNMP management are performed at a network management station running SNMP network
management application manager software with graphical user interface. The following figure
illustrates an example model:
The system unit serves as an SNMP agent and provides the capability that allows network
administrators via SNMP protocol to set parameters and view system status and media converter
status defined in the standard MIB-II and private MIB.

5.1 Configuring SNMP Settings via Console Operation

Before performing SNMP operation, proper SNMP settings must be configured in the system
unit. The SNMP related settings are:
Name : Logic name to identify a specific system unit
Location : Location where the system is installed
Contact : Contact person regarding the system
Community : SNMP communities to which the system belongs
and access right to the system (read only or read/write)
Trap hosts : IP addresses of trap hosts to which a trap is issued
and the trap community to which the system belongs.
Up to four SNMP communities and up to three trap hosts are supported by the system SNMP
agent.
These settings can be configured through console or telnet operation. Refer to Chapter 4 for
more information.
-37-