Verifying Installation; Verifying Start-Up Operations - Cisco SN 5428-2 Hardware Installation Manual

Verifying Installation

Verifying Installation

Caution

Verifying Start-up Operations

Step 1
Step 2
Step 3
Step 4
Step 5
Cisco SN 5428-2 Storage Router Hardware Installation Guide
2-30
Verifying installation of the SN 5428-2 Storage Router consists of making sure
that it starts up properly and that the network and Fibre Channel connections are
operational.
Fibre Channel ports should not be connected to zoned fabric until the SN 5428-2
Domain ID has been configured. See the
section on page 2-25. For information about configuring the Domain ID, see the
Cisco SN 5428-2 Storage Router Software Configuration Guide.
To verify that the storage router starts up properly, perform the following steps:
At the rear of the storage router, press the power switch to the on position.
At the front of the storage router, observe the POWER LED to make sure power
is on. Make sure that the FAULT LED is off.
Listen and check for air flow to make sure the fan assembly is operating.
Observe console output to make sure that the storage router software is booting
properly. The boot process may last for three to five minutes and will display boot
information and a banner. A successful boot-up is indicated by a CLI prompt for
user input.
If any of these conditions are not met, see
and, if possible, resolve the problem.
Chapter 2 Installing the SN 5428-2 Storage Router
"Connecting to a Fibre Channel Port"
Chapter 3, "Troubleshooting," to isolate
OL-4797-01