Cisco ASR 1000 Series Hardware Installation And Configuration Manual page 7

Chapter 2 Cisco ASR 1000 Series Routers Components
Table 2-3
Table 2-3
LED Label
PWR
STAT
MIN
MAJ
CRIT
BOOT
CARRIER
LINK
4 LEDs
PWR
STAT
Table 2-4
Table 2-4
Label
BITS
MGMT
OL-13208-01
lists the Cisco embedded ASR1000-RP1 LEDs and behaviors.
Cisco Embedded ASR1000-RP1 LEDs
LED
Power
System status
Minor
Major
Critical
EUSB0 FLASH
(BootDisk
10/100 /1000 RJ-45
Interface LED
Built-in SPA SFP
port status
SIP card power
SIP card status
lists the Cisco embedded ASR1000-RP1 connectors and description.
Cisco Embedded ASR1000-RP1 Connectors
Type
RJ45 connector
One RJ-45 jack for
copper Ethernet
Management Ethernet
Port
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
Color —State Behavior Description
Green All power requirements are within
specification
Green Cisco IOS has successfully booted.
Yellow BootROM has successfully loaded.
Red System failure.
Amber Minor alarm indicator.
Red Major alarm indicator.
Red Critical alarm indicator.
Flashing Green Active indicator.
Off No activity.
Off Out of service or not configured.
Green In frame and working properly.
Amber Fault or loop condition.
Green Link with no activity.
Flashing Green Link with activity.
Off No link.
Off Port is not enabled.
Amber Port enabled but there is a problem with the
Ethernet link.
Green Port enabled, valid Ethernet link
Green All SIP10 requirements are within specifi-
cation.
Green Only when the SPA drivers have started and
are running and all critical processes are
running
Yellow When ROMMON is running and during the
download and boot of the operating system
Red A fault is detected or the card is powering
up.
Description
Indicates BITS timing reference.
The route processor has an ENET port with a RJ-45
connector to attach a management device or network
for network management.
Cisco ASR 1000 Series Route Processor 1
2-7