Cisco Asr 1000 Series Spa Interface Processor - Cisco ASR 1000 Series Hardware Installation And Configuration Manual

Cisco ASR 1000 Series SPA Interface Processor

Figure 2-4
panel.
Figure 2-4
1
2
Table 2-5
Table 2-5
LED Label LED
1 PWR Power
3 STAT STATUS
2 ACTV Active
4 STBY Standby
Cisco ASR 1000 Series SPA Interface Processor
This section describes the SPA interface processor for the Cisco ASR 1006 Router, Cisco ASR 1004
Router and the Cisco ASR 1002 Router.
The Cisco ASR 1000 Series SPA Interface Processor for the Cisco ASR 1006 and Cisco ASR 1004
routers:
•
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
2-10
shows the Cisco ASR 1000 Series Embedded Services Processor (ESP10) LEDS on the front
Cisco ASR1000-ESP10 Faceplate LEDs
Power LED
Active LED
lists the Cisco ASR1000-ESP5 or ASR1000-ESP10 LEDs and behaviors.
Cisco ASR1000-ESP5 or ESP-10 Processor LEDs for the Cisco ASR 1002 Router
Is a carrier card that inserts into a router slot like a line card.
Chapter 2
2
1
PWR ACTV
STAT STBY
ASR1000-ESP10
3 4
3 Status LED
4 Standby LED
Color In the Power Up State -Behavior Description
Solid green All power supplies are within operational limits.
Off Off, the router is in standby mode.
Green Code has successfully downloaded and is
operational.
Yellow BOOT ROM has successfully loaded.
Red Not booted.
The embedded services processor is green when
Green
active.
None Will always be off.
Cisco ASR 1000 Series Routers Components
OL-13208-01