Cisco ASR 1000 Series Hardware Installation And Configuration Manual page 5

Chapter 2 Cisco ASR 1000 Series Routers Components
Table 2-1
No.
12
* The type of alarm triggered is associated with the driver itself. For example, environmental alarms are tied to our
environmental code, SONET alarms are tied to the sonet code, ENET to Ethernet.
Table 2-2
Table 2-2
No.
1
2
3
4
5
6
7
The Cisco ASR 1000 Series RP1 meets the following requirements:
Supports up to 4GB of ECC-protected memory with single-bit error correction and multi-bit error
•
detection
Supports On-board Failure Logging (OBFL) with 2MB of memory
•
Supports the Cisco ASR 1000 Series Router system architecture, midplane, and the Cisco ASR 1006
•
Router
Enhanced Serdes Interconnect (ESI) at 11.5 G bps.
•
Gigibit Ethernet switches for EOBC communication and boot-up of the Cisco ASR 1000 Series SPA
•
Interface (SIP) and Cisco ASR 1000 Series Embedded Services Processor.
Runs Cisco IOS network control plane (routing protocol, connections setup)
•
Cisco IOS punt packet forwarding
•
Active/Standby Cisco ASR 1000 Series Route Processor 1 and Cisco ASR 1000 Series Embedded
•
Services Processor selection
OL-13208-01
Cisco ASR 1000 Series Route Processor 1 LEDs (continued)
LED Label LED
LINK 10/100/1000 RJ-45
Interface LED
lists the Cisco ASR 1000 Series RP1 connectors and description.
Cisco ASR 1000 Series RP1 Connectors
Label Type
ACO Alarm cutoff switch.
0 USB connector 0
1 USB connector 1
BITS RJ45 connector
MGMT One RJ-45 jack for
ETHERNET copper Ethernet
Management Port
CON One RJ-45 for CON
AUX One RJ-45 for AUX
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
Cisco ASR 1000 Series Route Processor 1
Color —State Behavior Description
Solid Green Link with no activity.
Flashing Green Link with activity.
Off No link.
Description
When you press this button, an interrupt is
generated informing software that the
audible alarm relays will be disabled. This
interrupt generates to both processors.
Side-by-side USB connector used with
memory sticks or smart cards for secure key
distribution
Side-by-side USB connector used with
memory sticks or smart cards for secure key
distribution
Indicates BITS timing reference.
The route processor has an ENET port with
a RJ-45 connector to attach a management
device or network for network management.
Console port used to connect to a terminal.
Auxiliary port used for remote management
purposes.
2-5