Legrest; Seat Frame Tilt Stop Pads; Check-Out - Quickie S-636 Owner's Manual

S - 6 3 6 / S - 6 4 6
L. LEGREST 8 9
1. Legrest Length is adjusted in 5/8" increments
Remove Legrest from chair. Using a 5/32 hex wrench, remove the lower two 1/4-28
screws (A). Loosen, but do not remove the upper 1/4 -20 screw (B) until the extension
tube will slide within hanger. Reposition and reinstall screws.
2. Legrest Articulation (if so equipped)
The amount of articulation in the legrest may be adjusted from 1.5 to 2.5 inches.
To adjust:
a. Remove knee plate padding.
b. Remove screw A.
c. Remove top 1/4-20 screw (B) as shown.
d. Loosen screw C so knee plate rotates.
e. Rotate linkage so forward screw (D) is accessible beneath legrest.
f.Remove screw D and reposition linkage.
g. Note linkage extension positions: 1=2.5"; 2=2"; 3=1.5".
3. Calf Pad 10
Calf pad can be moved forward and rearward by repositioning it in different mounting
holes.
4. Footplate 11
Footplate may by angled or repositioned by loosening the 1/4-28 flathead screws (F)
located on the top of the footplate.
M. SEAT FRAME TILT STOP PADS
The position of the tilt stop pads (G) are adjustable vertically by loosening the jam nuts and
rotating the stop pads counter clockwise to raise (or clockwise to lower). The stop pads
should be positioned to support the seat frame at its lowest front position when the user
prefers a pre-tilted driving position. Once position is established, use jam nut to hold position
of stop pads on tower.
N. CHECK-OUT
Once the seating system is assembled and adjusted, it should operate smoothly and easily. All
accessories should also perform smoothly.
Repeat this procedure until the seating system performs to specifications before attempting
active use of the seating system.
If you have any problems, follow these procedures:
1. Review the set-up, check-out, operating and troubleshooting sections to make sure
seating system was properly prepared.
2. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise customer service. See the
introduction page for details on how to contact your authorized supplier or Sunrise
customer service.
108833 Rev. C
10 11
8 .
9a 9b
12
9a
22
X. OPERATING INSTRUCTIONS
B
A
D (not shown)
A
B
C
1
2
3
F
G
8
9a
9b
10
11
12