Table of Contents
Advertisement
2. RuggedBackbone™ Modules
2. RuggedBackbone™ Modules
The RX1501 chassis provides seven module slots . Each slot accommodates a particular type
of RuggedCom module.
on the RX1501.
Figure 2.1. RX1501 Chassis Slot Assignment
The RX1501 chassis supports the following modules:
LM1 through LM6
The RX1501 chassis supports up to six line module (LM) cards. For more information on line
modules, see
All modules are built to the RuggedRated™ specifications of the RuggedBackbone™ RX1501.
Each module type is described in the following sections.
To install a module into the RuggedBackbone™ chassis, align the module guide ribs
with the channels on the chassis. Push the module in as far as it will go, being sure to
push through the resistance provided by the grounding springs. When properly seated,
the module flange will rest on the main chassis frame. Tighten the thumbscrews using
finger strength only.
RuggedCom® RuggedBackbone™
Figure 2.1, "RX1501 Chassis Slot Assignment"
Section 2.2, "Line Modules
(LM)".
12
RX1501 Installation Guide Rev 104
shows the module slots
Advertisement
Table of Contents
