Adjusting The Audio Tone; Using The Clarity Boost Feature; Finding A Lost Handset - Uniden WDSS 5335+1 Owner's Manual

Adjusting the Audio Tone

If you aren't satisfied with the audio quality of your phone, you can adjust the Audio Tone of the earpiece while on
a call. Your phone gives you three audio tone options: low, natural and high; the default setting, Natural Tone, is
recommended for hearing aid users. Audio tone adjustments only apply to the earpiece, not the speakerphone.
To adjust the audio tone:
) With the phone in talk mode, press [select/
2) When the desired option appears on the display, stop.
3) After two seconds, the displayed audio tone is set, and the display returns to normal.

Using the Clarity Boost Feature

If you encounter interference while using your phone, you can manually improve the sound by setting the clarity
booster to on. To turn it on for the current call only, while you are on a call:
) Press [menu/clear].
Move the cursor to CLARITY BOOST, and then press [select/
2)
Use the same procedure to turn off clarity booster. BOOST OFF appears.
The clarity boost feature can also be turned on for all calls. See Activating Clarity Boost for All Calls on page 29.
The clarity boost feature uses additional battery power therefore talk time will be reduced. Return handset to charger
when not in use to keep battery fully charged.

Finding a Lost Handset

To locate a misplaced handset, press [find hs] on the base when the phone is in standby. All registered handsets
will beep for one minute, and PAGING appears on the handset display. To cancel paging, press [find hs] again or
any key on the found handset.
] to cycle through the three audio tone options.
]. BOOST ON and
36
appear in the display.