Troubleshooting - Kenmore 665.1326 Series Use & Care Manual

PROBLEM
DISHWASHER DOES NOT RUN NOTE: It is normal for the dishwasher to repeatedly pause several times during a cycle.
DETERGENT REMAINS IN THE
DISPENSER OR
TABLET IS ON BOTTOM
OF TUB
CYCLE RUNS TOO LONG
DISHWASHER NOT DRYING
WILL NOT FILL
WATER REMAINS IN THE TUB/
WILL NOT DRAIN
22

TROUBLESHOOTING

CHECK THESE POINTS TO HELP SAVE YOU TIME AND MONEY.
SOLUTION
If the Start/Resume light is blinking, close the door and push START/RESUME.
Be sure the door is closed and latched.
Check that there is not an interference with large casserole dishes and the wash system at the
back of the dishwasher. Adjust loading as necessary to ensure door is closed and latched.
Be sure you have disabled Sleep Mode by pressing either START/RESUME or CANCEL/DRAIN,
or opening the door before selecting your cycle/option.
Be sure you have selected a cycle. (See "Cycles and Options Information.")
Be sure there is power to the dishwasher. A circuit breaker or fuse may have tripped.
If lights other than Start/Resume blink and the unit will not run, you will need to call for service.
Check for dishware such as cookie sheets, cutting boards, or large containers, etc., that may be
blocking the detergent dispenser from opening properly.
Be sure your detergent is fresh and lump free.
Be sure the cycle has completed (blue light is on). If it has not completed, you will need to resume
the cycle by closing the door and pressing START/RESUME.
NOTES:
To use less water and reduce energy consumption you will encounter cycles that typically run
for up to 3 hours.
A water heater setting of 120°F (49ºC) is best. The dishwasher will delay longer while heating
cooler water.
Some options will add time to the cycle. (See "Cycles and Options Information" section.) The
Heated Dry option adds ½ hour.
Try the 1 Hour Wash cycle.
Run the hot water at a faucet close to the dishwasher before selecting and starting the cycle.
NOTE: Plastic and items with nonstick surfaces are difficult to dry because they have a porous
surface which tends to collect water droplets. Towel drying may be necessary.
Use of rinse aid along with the Heated Dry option is needed for proper drying.
Proper loading of items can affect drying. (See specific loading instructions within this guide.)
Glasses and cups with concave bottoms hold water. This water may spill onto other items when
unloading.
Unload the bottom rack first.
Locate these items on the more slanted side of the rack for improved results.
Be sure the water is turned on to the dishwasher.
Check that the float is free from obstructions. (See "Parts and Features.")
Check for suds in the dishwasher. If foam or suds are detected, the dishwasher may not operate
properly or may not fill with water.
Be sure the cycle has completed (the blue light is on). If it has not, you will need to resume the
cycle by closing the door and pressing START/RESUME.
If dishwasher is connected to a food waste disposer, be sure the knockout plug has been
removed from the disposer inlet.
Check for kinks in the drain hose.
Check for food obstructions in the drain or disposer.
Check your house fuse or circuit breaker.