Troubleshooting - Kenmore ULTRACLEAN 665.1456 Series Use & Care Manual

PROBLEM
DISHWASHER DOES
NOT RUN
DETERGENT REMAINS IN
THE DISPENSER OR TABLET
IS ON BOTTOM OF TUB
CYCLE RUNS TOO LONG
DISHWASHER NOT DRYING
WILL NOT FILL

TROUBLESHOOTING

CHECK THESE POINTS TO HELP SAVE YOU TIME AND MONEY
SOLUTION
NOTE: It is normal for the dishwasher to repeatedly pause several times during a cycle.
If the Start/Resume light is blinking:
Press START/RESUME and close the door within 4 seconds.
Be sure the door is closed and latched.
Check that there is not an interference with large casserole dishes and the wash system
■
at the back of the dishwasher.
Check to see if any items are protruding through the bottom or back of the rack. Also
■
check to see if tall items are hitting the upper rack or spray arm. Adjust loading as
necessary to ensure door is closed and latched.
Press START/RESUME or CANCEL, or open and close the door before selecting your cycle/
option. Controls must be awakened after a period of inactivity.
Be sure the Control/Lock feature is not on. If the control lock indicator is lit, press and hold
CONTROL LOCK for 3 seconds. The control lock LED will turn off and you can then operate
the controls.
Be sure you have selected a cycle. See "Cycles and Options Information" section.
Be sure there is power to the dishwasher. A circuit breaker or fuse may have tripped.
If lights other than Start/Resume blink and the unit will not run, you will need to call for service.
Check for dishware, such as cookie sheets, cutting boards, or large containers, etc., that may be
blocking the detergent dispenser from opening properly.
Be sure your detergent is fresh and lump free.
If the cycle has completed, the Complete indicator light will be on in the display. If it has not
completed, you will need to resume the cycle by closing the door and pressing Start/Resume.
NOTES:
To use less water and reduce energy consumption, you will encounter cycles that typically run
■
for up to 3 hours. Efficient dishwashers run longer to save water and energy, just as driving a
car slower saves on gas.
A water heater setting of 120°F (49°C) is best; the dishwasher will delay longer while heating
■
cooler water.
Some options will add time to the cycle. See the "Cycles and Options Information" section.
■
The Turbo Heat Dry option adds up to 46 minutes.
Try the 1 Hour Wash cycle. The 1 Hour Wash cycle uses more energy and water to clean the
dishes in less time.
Run the hot water at a faucet close to the dishwasher before starting the cycle.
NOTE: Plastic and items with nonstick surfaces are difficult to dry because they have a porous
surface which tends to collect water droplets. Towel drying may be necessary.
Use of rinse aid along with the Turbo Heat Dry option is needed for proper drying.
Proper loading of items can affect drying. (See specific loading instructions within this guide.)
Glasses and cups with concave bottoms hold water. This water may spill onto other items
when unloading.
Unload the bottom rack first.
■
Locate these items on the more slanted side of the rack for improved results.
■
Be sure the water is turned on to the dishwasher.
Check that the overfill protection float is free from obstructions. See "Parts and Features" section.
Check for suds in the dishwasher. If foam or suds are detected, the dishwasher may not operate
properly or may not fill with water. See "Blinking Lights" in "Troubleshooting" section.
21