Using The Valet Switch; Transmitter Protection & Technology; Programming Transmitters - Excalibur RS-250-DP Operation Manual

Using The Valet Switch

Valet Mode
Valet mode disables the remote start feature. It should be used, for example,
when you have your vehicle serviced. To engage Valet Mode:
• With the system "unlocked", press and hold the Valet Switch for 3 seconds; the
Status Light(optional) will turn on to indicate Valet Mode. Attempts to remote start
will result in no response. keep this in mind if remote start stops functioning.
• To turn off Valet Mode, simply press & release the Valet Switch once. The Status
Light will turn off.
Manual Override
This puts the system in an "unlocked" state allowing for programming operations.
• Turn the vehicle's ignition "on".
• Press and release the valet switch once.
Transmitter Protection & Technology
TM
Code Jumping Technology
Code jumping technology uses a complex algorithm to change the transmitter's
codes every time a button is pressed to prevent a thief from copying the signal. Only
the system in your car has the key to decipher this code and it is not replicable.
Automatic Transmitter Verification
There the potential threat of someone, who has temporary access to your ve-
hicle, programming their own transmitter to your system. For example, a mechanic,
car wash attendant, or valet could do so and gather your personal info from any
paper work in your vehicle. Then, they could visit your home and help themselves
to the contents of your vehicle without any signs of intrusion. Many crimes go un-
noticed and people assume they have misplaced their belongings. ATV
how many transmitters are programmed to your system by flashing the status light
(optional) every time you turn on the ignition key for a 10 second period. Then, you
can easily identify if transmitters have been added to your system.

Programming Transmitters

Standard Programming: Before starting, be sure the system is in an "unlocked"
state by using a working transmitter or performing a manual override.
Step 1
have all transmitters which are to operate the system at hand. Then,
turn the ignition "on".
Step 2 within 5 seconds of turning on the ignition, press the Valet Switch 5
times. The status light (optional) and parking lights will illuminate, confirming that for
the next 10 seconds the system is ready to learn a transmitter/controller code. To
enter a code, simply press and release the transmitter button. When the first code is
learned all existing stored codes will be erased.
Step 3 Press the button on each remaining transmitter one at a time. The sys-
tem will turn the lights off then back on to confirm that each was learned. If a code
is not received within a 10 second period, the learning process will automatically
terminate, as indicated by the lights turning off.
Step 4 Turn the vehicle's ignition key "off".
6
TM
TM
shows you