Adjusting Footplate Height - Invacare Tracer SX5 User Manual

Adjusting Footplate Height

 For this procedure, refer to FIGURE 2.
This procedure applies to the swingaway front
riggings and swingaway elevating legrest.
1. Remove the front rigging assembly. Refer to Installing/Removing
Front Riggings on page 34.
 Lay the front rigging assembly on a flat surface to
simplify this procedure.
2. Pull the cam lock lever up to unlocked position.
NOTE: The elevating legrest has two sets of release buttons, one set above the
other. Each set will be visible one at a time allowing finer footplate height
adjustment.
3. Push in the release buttons and reposition the footplate assembly
to the desired height.
4. Ensure that the release buttons fully protrude from holes on both
sides of the front rigging support.
5. Rotate cam lock lever down to locked position.
6. Repeat this procedure for the other footplate, if necessary.
7. Reinstall the swingaway front rigging assembly. Refer to
Installing/Removing Front Riggings on page 34.
Part No. 1110550
Adjustment
Holes
Cam Lock Lever

FIGURE 2
35
7 FRONT RIGGINGS
Front Rigging Support
Release Button
Footplate
Assembly
Swingaway footrest shown.
Adjusting Footplate Height
®
Tracer SX5