Creating Original Sounds Via The Knobs; Selecting A Knob Effect Combination; Applying The Filter To The Main Voice - Yamaha PSR-E443 Quick Manual

Creating Original Sounds via the Knobs

The two knobs located in the lower left area of the panel can be used to add variations
to the sound being played, transforming the sound in a variety of musical ways. Select
the desired pre-programmed effect combination printed above the Knobs, then rotate
the Knobs to enjoy the sound.
Selecting a Knob Effect Combi-
nation
Repeatedly press the [ASSIGN] button to sequentially
select the five effect combinations provided: (1)
   
(3) (4) (5) (6)
combination is shown in the display.
GrandPno
001
The target sound differs depending on the effect com-
bination (selected number).
Effect
Target Sound and Function
Combination
1 FILTER
Controls the sound of the Main Voice and Dual
2 EFFECT
Voice.
3 EG
STYLE Controls the sound of the Style (page 23) or
4
FILTER Pattern (page 24)
Controls mainly audio sound coming from an
external audio device connected to the AUX IN
jack.
5 AUX IN
* Knob B can be used to control the volume of Style/
Song/Pattern sound with the keyboard sound main-
tained, even if an external audio device is not con-
nected.
SPECIAL Knob A controls the entire sound while Knob B
6
EFFECT controls only the Pattern sound.
For details about each Knob effect, refer to page 41.
NOTE
• Only selecting a Knob effect combination will not affect the
sound even if the Knob arrow is not at the initial position. After
operating the Knob, the selected effect is applied to the
sound.
22
PSR-E443 Owner's Manual

(2)

(1) ... etc. The current
001
Current value
Applying the Filter to the Main
Voice
1
Select the desired Main Voice.
Here, select "Voice No.153 SquareLd" (Square
Lead) as a synth-lead type Voice.
2
Press the [ASSIGN] button several times
until (1) (Filter) appears in the display.
3
Rotate Knob B all the way to the right
(maximum), then play the keyboard with
your right hand while operating Knob A
with your left.
Filter
Cutoff
NOTICE
• When z or x or c appears in the display by pressing
[ASSIGN] button, selecting a different Voice will
replace the settings created via the Knobs with the
default settings of the new Voice. If you create a
sound with the Knobs that you wish to keep, make
sure to memorize the settings to Registration Memory
(page 33) before selecting a different Voice.
NOTE
• Rotating a Knob to the right while the volume is set to a
high level may result in distortion. If this occurs, reduce
the volume level.
Filter
Resonance