Step 10 - Final Preparation; Routine Maintenance - Friedrich Breeze BRO412W1A Installation Instructions Manual

STEP 9 – Locate the condensate drain.
The connecting line has a built in condensate line hose that removes the moisture collected from the indoor module.
The hose must be located in an appropriate location for drainage. Because the hose relies on gravity to drain, it is
important that the hose only points downward for the entire length of the hose.
If the connecting line is rolled to store the excess line as shown in Step 6, the drain line may be removed from the
connecting line as shown below and cut to an appropriate
length.
STEP 10 – Final Preparation.
Using the supplied connecting line clips (Item #13 in the
Accessories List), secure the connecting line to the interior and
exterior walls as desired. 5 retaining clips are provided from the
factory along with standard #8 x 1 1/2" screws and wall anchors.
For installations with the connecting line going through the
wall (option 1) use the supplied filler gasket (Item #6 in the
Accessories List) to plug the hole around the connecting line in
the wall opening. Additional sealing may be desired or necessary
for proper weatherproofing.
Once the connecting line is secure and Steps 1-9 are complete,
you may plug in the Breeze system and enjoy your new air
conditioner.

Routine Maintenance

Cleaning the unit:
The outer cover of the Breeze indoor module can be cleaned with a damp
cloth.
Cleaning the outdoor module can be done by rinsing the module with low
pressure water. Refer to friedrich.com for approved coil cleaning agents.
Cleaning the filter:
The indoor module of the Breeze system has a washable filter that
should be inspected and cleaned periodically. To access and clean the
filter follow these steps.
1. Open the front panel by pulling on the left and right side tabs. The
front panel will open upward and lock into the open position.
2. Remove the left and right air filters from the Breeze module.
3. Wash the filters by rinsing with water or by vacuuming the dirt from
the filter. Allow the filter to dry completely prior to reinstalling.
4. Reinsert both air filters. Then, lower the front panel and snap the
panel into place.
SCORE AND PEEL
STEP 9
1.
2.
3.
4.
SCORE AND PEEL
Peel away