Seco-larm no touch request-to-exit sensor specification sheet (1 page)
Summary of Contents for ENFORCER E-931CS22RFCQ
Page 1
E-931CS22RFCQ Wireless Entry Alert System Manual For monitoring a driveway or for use as an entrance indicator No wiring necessary between sensor and speaker Sensor range: Up to 22ft (7m) Sensor is weatherproof for outdoor use ...
ENFORCER Wireless Entry Alert System Introduction: The ENFORCER Wireless Entry Alert System is a self-contained easy-to-install alert system for commercial or home applications. Each set contains a reflective photoelectric beam sensor that, when tripped, communicates wirelessly with a speaker installed up to 328ft (100m) away*. An additional speaker may be installed to alert more than one area on the property and an optional solar charger may be installed with the sensor for even more convenience.
Page 3
ENFORCER Wireless Entry Alert System Installation: 1. Install the reflector and sensor so they face each other about 2ft (61cm) off the ground. 2. Install the speaker within 328ft (100m) of the sensor. 3. Connect an included power adapter to the sensor. If optional solar charger is used, see pg. 4, Installing the Optional Solar Charger.
ENFORCER Wireless Entry Alert System Installing the Optional Solar Charger (E-931ACC-SPQ) 1. Install the solar panel in an area exposed to sunlight. 5. Connect the solar charger’s DC plug to the sensor’s DC 2. Use the included Phillips screwdriver to remove the jack.
Need help?
Do you have a question about the E-931CS22RFCQ and is the answer not in the manual?
Questions and answers