Lan Configuration; Ddns Configuration - Thecus N299 User Manual

LAN Configuration

The N299 supports a second
Ethernet port for higher service
availability. To configure these ports,
choose LAN from the Network
menu, and the LAN Configuration
screen appears. Press Apply to save
your changes.
LAN Configuration
Item
MAC Address
Jumbo Frame Support
IP
Netmask
DHCP Server Configuration
Item
DHCP Server
Start IP
End IP
DNS Server
Apply
Cancel
NOTE
WARNING
D DN S Configuration
T he N299 also fe atures
from the Network men
DDNS Support
Item
Register
User Name
Password
Domain Name
Apply
Cancel
Description
Displays the MAC address of the LAN interface.
Enable or disable Jumbo Frame Support on the LAN interface.
Specifies the IP address of the LAN interface.
Specifies the Network Mask of the LAN interface.
Description
Enable or disable the DHCP server to automatically assign IP
addresses to PCs connected to the LAN interface. Default is
Disabled.
Specifies the starting IP address of the DHCP range.
Specifies the ending IP address of the DHCP range.
Specifies the DNS server IP address.
Click Apply to save your changes.
Click Cancel to abandon your changes.
• Before enabling Jumbo Frame Support, please make sure your network
equipment supports Jumbo Frame. If your equipment is incompatible, you might
not be able to connect to your N299. In this case, you have to reset the system
back to default by the holding down rear panel reset button for 15 seconds
during boot up process.
• The IP Segment of WAN and LAN should not overlap.
The IP address of the LAN interface should not be in the range of the Start IP
address and End IP address.
Dynamic DN S support. To configure DDNS, choose DDN
u. Press Apply to confirm your settings.
Description
Support www.dyndns.org, www.zoneedit.com,
Input user name that you have register in DDN
Input password that you have register in DDNS domai
Input registered domain name.
Click Apply to save your changes.
Input Click Cancel to abandon your changes.
30
S
www.tzo.com
S domain.
n.