Tiger SIDE FLAIL JD 5065M-105M CAB Operating Instructions Manual page 100

MAINTENANCE
GREASING THE UPPER AND LOWER SHEAVES
Locate the grease zerks on the ends of the upper
and lower sheave pins. Mnt-R-0018 Inject Lithium-
Complex Extreme Pressure grease conforming to
NLGI2-ISO 320 specifications into each pin until it
protrudes from the ends. These should also be
greased daily or for every 8 hours of service.
GREASING P.T.O. SHAFTS
After bringing the tractor to a complete stop, shut off
the engine and remove he PTO shaft from the
tractor. Slide the shaft apart to expose the grease
zerk. Grease the shaft with 5 pumps of grease and
the U-joints until grease protrudes from caps per
the scheduled interval in the maintenance section.
GREASING INNER AND OUTER DRAFT BEAM PIVOT POINTS
Locate the grease zerks on the inner and outer draft beam pivot bosses. Inject Lithium-Complex Extreme
Pressure grease conforming to NLGI2-ISO 320 specifications into each zerk until grease protrudes from joints.
Grease all pivot points daily or every 8 hours of service.
Side and Rear Flail Maintenance Section 4-12
©2011 Alamo Group Inc.