Table of Contents
Advertisement
A
Using UEFI setup screens
11. Press Enter. The selected device will be added to the list of boot devices for the adapter on the Boot
FIGURE 7
12. Save or exit the configuration utility.
Using UEFI setup screens
For UEFI systems or UEFI boot mode, use steps in this section to configure boot over SAN and other
adapter storage functions using your system's UEFI setup utility Storage menu options. These general
instructions are applicable to IBM host systems. Refer to your system's documentation or online help
for specific details on using your UEFI setup screens.
NOTE
When you change a setting on a UEFI setup screen, the setting is saved to the adapter whenever you
change to a new screen within the adapter configuration or when you close the utility. Changes are
effective even before you explicitly save them.
1.
2. Access your UEFI setup screens by booting the system and pressing the F1 key when prompted for
40
NOTE
You only need to select the bootable LUN once. After the first boot, the same LUN will be used
until changed through the BIOS Configuration Utility.
Device Settings screen
(Figure
BIOS Configuration Menu (Boot Device Settings)
•
To save the configuration, press Alt + S.
•
To exit without saving, press the Alt + Q.
Power on or reboot the host system.
configuration or setup.
The System Configuration and Boot Management menu displays.
7.)
IBM Flex System FC5024D 4-Port 16Gb FC Adapter User's Guide
Advertisement
Table of Contents
