Table of Contents
Advertisement
Fig.7-12
Art No 215-0028 - Handrail fascia fixings
Fig.7-13
ArtNo.350-0012 - Securing the plinth
Fig.7-14
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
Fig.7-15
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Outer plinth xing screw
Inner plinth
Fig.7-16
Check the appliance is electrically safe when you have nished.
Outer plinth
INSTALLATION
Remove the 4 mm Allen screws from the top corners of the
fascia (Fig.7-12). Fit the front handrail in position and secure
using the 4 mm screws.
Fitting the Plinth
Loosen the three screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and t each end keyhole over their respective screws. Tighten
the xing screws (Fig.7-13).
Fitting the Plinth
Fit the inner plinth to the bottom front of the cooker using
the 4 screws provided (Fig.7-14).
Fit the outer plinth (2 screws, 1 each end) to the inner plinth.
The height of the outer plinth can be adjusted by sliding it up
or down via the slotted hole (Fig.7-15).
Fitting the Plinth
O er the keyhole slots on the outer plinth to the location
points on the inner plinth (Fig.7-16).
When released the outer plinth should automatically adjust
to the oor height (Fig.7-16).
WARNING: When moving the cooker ensure that the
n
n
outer plinth is removed. Failure to do so may result
in damage to plinth and oor.
Fitting the Splashback
Position the splashback on the rear of the hotplate and secure
with the screws supplied.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
30
(Kitchener and Toledo)
(Hi-LITE)
(optional)
Advertisement
Table of Contents
