Motor Locks - Quickie P-220 User Instruction Manual & Warranty

42
• Push up the on/off mode select toggle switch to index among the five drive and
actuator modes. The selected mode indicator will flash.
• Push joystick either left or right to select one of the five drive profiles. To select
the actuator modes, push up on the mode select switch twice.
• The drive profiles are indicated by the mode indicators (G) and the actuators are
indicated by the four actuator lights (H).
• To exit drive or actuator mode select, simply push the on/off/mode toggle up one
or more times until the indicator no longer flashes, or push the joystick forward
or reverse to begin driving.
5. Joystick (E)
The joystick controls the direction and speed of your chair. Turn the chair on and move
the joystick in the direction you want to go.
• Moving the joystick from the neutral (center) position disengages the motor
locks, allowing the chair to move.
• The chair will move faster the more you move the joystick away from neutral.
NOTE– If your speed becomes hard to manage, release the Joystick and the chair will
come to a complete stop.
• When you release the joystick it will return to neutral; the chair will slow to a
stop and the motor locks will reengage.
• We recommend that you switch the chair off if you stop for any length of time.
This will conserve battery power.
NOTE– Once the chair stops, switching the chair off will not affect the motor locks.
6. Joystick Boot (F)
Make sure the boot is not torn or cracked (this could allow debris, water or moisture
to enter). If the boot is torn or cracked, replace it as soon as you can.
7. Remote Switch Jacks (optional– not shown)
Two 1/8" switch jacks are optional to provide remote switch control of the on/off
power function and the mode select function. Any of the single switches offered by
Sunrise Medical can be used to connect to either or both of these jacks (except the
single zero touch switch).
1. Never use the ON/OFF switch to stop your chair except in an emergency.
This will result in an abrupt stop, and may cause you to fall.
2. To slow or stop your chair, return the joystick to neutral.
930475 Rev. D
X . O p e r a t i n g G u i d e X . O p e r a t i n g G u i d e
G. MOTOR LOCKS
Disconnect the motor locks when you need to manually
push the chair. (For example, in an emergency,
or if batteries fail).
1. Do not disengage motor locks unless power to
the chair is off.
2. Be aware that the chair will not have brakes
in the free-wheel position.
3. Make sure that the person pushing the chair has
full control when motor locks are disengaged.
1. To Disengage Motor Locks:
Lift the lever (A) to the free-wheel position.
2. To Engage Motor Locks:
Push the lever (A) down into the drive position.
43
A
930475 Rev. D