Telephone Base And Charger Installation; Battery Installation - VTech CS6428-2 User Manual

Telephone base and charger installation

Install the telephone base and charger as shown below.
Telephone base
power adapter
Electrical outlet
not controlled
by a wall switch
• Use only the power adapter and battery supplied with this product. To order a
replacement, visit our website at www.vtechphones.com or call  (800) 595-95.
In Canada, go to www.vtechcanada.com or call  (800) 267-7377.
• The power adapter is intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into
a ceiling, under-the-table or cabinet outlet.
• If you subscribe to telephone service from a cable company or a VoIP service
provider, plug the telephone line cord into the modem/router/terminal adapter
provided by your cable/VoIP service provider. Contact your cable/VoIP service
provider if you have any difficulties in installation.

Battery installation

Install the battery as shown below.
. Plug the battery connector
securely into the socket.
3. Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
• If the handset will not be used for a long time, disconnect and remove the battery to
prevent possible leakage.
IMPORTANT:
Check for a dial tone by pressing
is successful.
If you do not hear a dial tone:
• Make sure the installation procedures described above are properly done.
• It may be a wiring problem. If you have changed your telephone service to
digital service from a cable company or a VoIP service provider, the telephone
line may need to be rewired to allow all existing telephone jacks to work. Refer
to Rewiring of telephone line for cable/VoIP service users on page 9 for
more information.
Telephone wall jack
Telephone base
A DSL filter (not included)
is required if you have DSL
high-speed Internet service
Telephone line cord
2. Place the battery with the label
THIS SIDE UP facing up and the wires
inside the battery compartment.
4. Place the handset in the telephone
base or charger to charge.
CHARGE light
remains on
when charging.
. If you hear a dial tone, the installation
2
Charger adapter
Electrical outlet
not controlled
by a wall switch
Charger