Table of Contents
Advertisement
P
RINTING FROM
C
ANNOT CONFIGURE FOR PARALLEL CONNECTION
POSSIBLE CAUSE
The computer does not
support bi-directional parallel
interface.
Parallel cable does not meet
specifications.
The interface is disabled.
Configuration procedure was
not correctly followed or
cancelled.
Parallel cable is disconnected
or faulty.
A converter, buffer or
extension cable is being used.
C
ANNOT CONFIGURE FOR
NOTE
> Windows 95 does not support USB.
> Windows 98 upgraded from Windows 95 may not support
USB.
> Windows 98 SE and Windows Me, 2000 and XP all support
USB.
POSSIBLE CAUSE
Computer does not support
USB interface.
USB cable does not meet
specifications.
Interface is disabled.
Configuration procedure was
not correctly followed or
cancelled.
W
INDOWS
REMEDY
There is no cure for this problem. You should
only use a computer that does!
Use a bi-directional parallel cable to IEEE
1284–1994 standard.
Check that the parallel interface is set to
enable.
Configure again from the beginning.
Reconnect or try another cable.
Test by connecting printer and computer
directly.
USB
CONNECTION
REMEDY
Check if there is a USB controller in the
Windows device manager.
Use USB cable to specification Ver. 2.0.
Check that USB interface is set to Enable.
Configure again from the beginning.
C7350 User's Guide> 158
Advertisement
Table of Contents
